Polaris Sportsman XP 1000 S 2022 Owner's Manual page 125

1. Position the vehicle on a level surface with the headlight approximately 25 ft.
(7.6 m) from a wall
2. Measure the distance from the floor to the center of the headlight and make a
mark on the wall at the same height.
3. Start the engine. Turn the headlight switch to high beam.
4. Observe the headlight aim on the wall. The most intense part of the headlight
beam should be 2 in. (5 cm) below the mark on the wall
weight on the seat when measuring.
5. The adjustment screw is located on the left side of the headlight pod. To
adjust the beam, loosen the screw. Adjust the headlamp to the desired
position, then tighten the screw.
LOW BEAM ADJUSTMENT
The low beam can be adjusted slightly upward or downward by rotating the
adjustment screw, located on either side of the vehicle.
HEADLIGHT HOUSING REPLACEMENT
1. Remove the four (4) headlight pod screws.
2. Pull the pod cover forward.
3. Unplug the headlamp from the wiring harness.
4. Use a small screwdriver to remove the o-rings from the headlight mounting
tabs.
5. Pull the headlight housing up from the bracket for removal.
6. Reverse the steps to install the new housing and reassemble the pod.
LOWER HEADLAMP REPLACEMENT
1. Turn the back of the headlight harness counter-clockwise and pull the
harness assembly away from the headlight assembly.
2. Remove the headlamp and install the new headlamp.
3. Reinstall the harness assembly into the headlight assembly.
Take care to avoid touching the glass on the new headlight bulb. Fingerprints
4. Turn the headlight harness clockwise to secure the headlamp.
q
. Place the transmission in PARK.
on the glass may result in premature failure.
NOTE
MAINTENANCE
w
. Include rider
123