Component Set - Hitachi 53SDX01B Operating Manual

SET UP
MAGIC FOCUS
Your HITACHI Projection TV has three color projection tubes: one for red, one for green, one for blue. When
mixed together in the proper proportion, the output of these three colors tubes can produce any color. To produce
these colors, however, the beams must be precisely aligned over each other so that the colors can be mixed. The
process of aligning these picture beams is called "convergence".
Over a period of time, the picture tubes can drift out of alignment due to normal bumps and vibrations or moving
the TV. If you move your TV, or if, after a time, you notice color rings or halos around objects in the picture, you
may want to converge (align) the colors.
Properly converged, the lines appear white, which is actually a combination of the outputs of the three color tubes.
The output of the green tube is stationary. The outputs of the red and blue tubes can be adjusted. When properly
aligned, the outputs of all three tubes should be directly over each other to produce the white lines.
To simplify convergence, HITACHI incorporates a function called MAGIC FOCUS, which the TV to self-adjust.
This process will take approximately 45 seconds. If this button is pressed during this 45 second period, no
change is picture quality will occur. After this 45 second self-adjust period, picture quality will be optimum. (Do
not move the TV during self-adjust.)
To enter this self-adjust mode, you may also select MAGIC FOCUS from the SETUP Menu. However, this will
display a message prompting you to press the front panel MAGIC FOCUS button.
NOTES: Only a momentary press of the MAGIC FOCUS button is necessary to start AUTO DIGITAL
CONVERGENCE. At anytime during this convergence correction process, you may press the MAGIC FOCUS
button to exit the MAGIC FOCUS mode.
Do not press the MAGIC FOCUS button for more than three seconds. This is only for extreme cases of
misconvergence and requires assistance from service. If one of the pictures shown below appears on the
television screen, press the MAGIC FOCUS button a second time to exit this manual set up mode.

COMPONENT SET

The COMPONENT SET function is very useful when setting up reception High Definition, Standard Definition and
NTSC signals.
64