Using The Remote To Control Satellite Receiver Functions - Hitachi 53SDX01B Operating Manual

USING THE REMOTE TO CONTROL SATELLITE RECEIVER FUNCTIONS

These buttons transmit the chosen precoded cable codes.
(3) EXCLUSIVE TV buttons
These buttons are for operating the TV.
MY CABLE BOX CODE IS:___________________
NOTE: Refer to instruction manual of the Cable Box for operation of the buttons exclusively for the Cable Box.
USING THE REMOTE TO CONTROL SATELLITE RECEIVER FUNCTIONS
Operating the precoded function for your satellite receiver.
This remote is designed to operate different types of satellite systems. You must first program the remote to match the remote
system of your satellite receiver. (refer to page 37.)
1. Turn ON your satellite receiver.
2. Aim the remote control at the front of your satellite receiver.
3. Press the SATELLITE (SAT) button on the remote to switch to satellite pre-coded mode.
4. Hold down the SAT button on the remote and enter the two digit preset code that matches your satellite receiver as shown
on page 37. The indicator light will flash 3 times if the code was accepted.
5. Aim the remote at the satellite receiver and press the POWER button. The remote will turn off your satellite receiver when
the correct two digit preset code is entered. When this occurs, the remote control is programmed for your satellite receiver. If
the satellite receiver does not turn off, try a different two digit preset code.
6. The remote will now control your satellite receiver.
44