Advertisement
3. OPERATION
1. Manual Arbor Press
a. The Manual Arbor Press has a hand lever which the operator rotates forward to move the ram from its
top dead center position to its full bottom dead center position. The press stroke limiter does not allow
the press to return to top dead center until it reaches its full bottom dead center position. If necessary,
the stroke limiter can be overridden by pulling out its front spring-loaded knob and allowing the lever
and press ram to return to their top dead center position.
2. Tooling Packs
a. The Tooling Packs are installed into the Manual Arbor Press by sliding the square nuts attached to the
base plate of the Tooling Pack into the T-slot of the Arbor Press base. Before tightening the base plate
screws, pull out the locking plunger and raise the top plate of the Tooling Pack until it engages the
stepped ram collar. Release the locking plunger. Then tighten base plate screws to fully fasten the
Tooling Pack into the Manual Arbor Press.
Rev A
Figure 2
Figure 3
408-160034
2 of 8
Advertisement
