Troubleshooting; Specifications - Panasonic DH-3RL1 Operating Instructions Manual

4. TROUBLESHOOTING

(1) Check the following points before asking for repair.
Symptom
Water is not drawn 1. Check the Filter Unit. Clean the Filter if it is clogged by stain and dirt (refer to Filter Unit Cleaning
normally.
2. Check the Shower Head. Clean the Shower Head if it is clogged by dirt (refer to Shower Head
No hot water comes out 1. Make sure the Main Switch Knob is at "On" position.
from the outlet 2. Make sure the ELB Reset Lever is not slide down.
(no electric supply to the
Unit) 3. Make sure to switch on the ON/OFF DP (double pole) Switch.
4. Make sure to switch on the Miniature Circuit Breaker (MCB)
No water flows out from 1. Check the Water Volume Knob. Turn the Water Volume Knob clockwise if it is closed.
the Shower Head at all. 2. Check the Main Water Valve. Turn "On" the Main Water Valve if it is closed (refer to HOW TO
Water not hot enough. 1. Check the WATER FLOW RATE ADJUSTMENT as in page 15.
(2) If abnormalities as mentioned below are found during use, please do not use the Unit and contact your authorized dealer immediately.
• Water leakage.
• No Water Flow.
• Water temperature cannot be controlled.
• ELB lamp does not light up.
(3) Special skill is required for repairing. Never try to repair the Unit by yourself.

5. SPECIFICATIONS

Model No.
Voltage
Power Consumption
Electric Power Control
Min. Water Pressure
Max. Water Pressure
Dimension
Weight
Outlet System
at page 16).
Cleaning at page 16).
Push up the ELB Reset Lever to reset the ELB (refer to TEST OPERATION at page 21).
USE at page 15).
DH-3RL1
Inlet Water Temp. (Off), 1000 W ~ 3600 W
9.8 kPa / 0.1 kgf/cm² / 1.42 psi
380(H) mm x 190(W) mm x 93(D) mm
1.6 kg
Single Point System (Open Outlet)
- 17 -
Points to be checked
240 V a.c. 50 Hz
3600 W
4.9 kPa / 0.05 kgf/cm² / 0.71 psi
380 kPa / 3.87 kgf/cm² / 55 psi
DH-3RP1
2.7 kg