Gigabyte GA-F2A88X-D3HP User Manual page 26

8) F_PANEL (Front Panel Header)
on the chassis to this header according to the pin assignments below. Note the positive and negative pins
before connecting the cables.
PLED/PWR_LED
System Status LED
S0 On
Off
PW
system using the power switch (refer to Chapter 2, "BIOS Setup," "Power Management," for more
SPEAK
Connects to the speaker on the chassis front panel. The system reports system startup status by issuing
a beep code. One single short beep will be heard if no problem is detected at system startup.
HD
Connects to the hard drive activity LED on the chassis front panel. The LED is on when the hard drive
is reading or writing data.
RES
Connects to the reset switch on the chassis front panel. Press the reset switch to restart the computer
if the computer freezes and fails to perform a normal restart.
CI
NC No connection.
The front panel design may differ by chassis. A front panel module mainly consists of power switch,
reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis
front panel module to this header, make sure the wire assignments and the pin assignments are
matched correctly.
Hardware Installation
Power LED
2
1
Hard Drive
Activity LED Switch
Connects to the power status indicator on the chassis front panel. The LED
- 26 -
Power Switch Speaker
20
19
Power LED
Chassis Intrusion
Header