en Basic operation
To start the washing program,
4.
press the start button on the wash-
ing machine.
Charging the appliance
Use the supplied charging cable to
charge the appliance.
Connect the charging cable to a
1.
USB port.
Connect the charging cable to the
2.
appliance charging socket.
a The status LED lights up red.
a When it is switched off, the touch
display shows the battery charging
status. When it is switched on, it
shows the status bar.
a Once the battery is fully charged,
the status LED lights up green.
Disconnect the charging cable
3.
from the appliance.
Disconnect the charging cable
4.
from the USB port.
Returning the appliance to
standby mode
Press the
button.
▶
a The status LED flashes green.
Restarting the appliance
Press the
button for 7 seconds.
▶
a The appliance restarts.
36
Switching off the appliance
Press and hold the
1.
3 seconds.
a The touch display shows "Do you
want to switch off the device?".
Touch Yes.
2.
a The appliance switches off.
Calibrating the appliance
The appliance prompts you to calib-
rate at regular intervals.
You can calibrate the appliance im-
mediately or later.
Note: Calibrating the appliance later
will affect the detection accuracy.
→ "Calibrating the appliance automat-
ically", Page 36
→ "Calibrating the appliance manu-
ally", Page 37
Calibrating the appliance
automatically
Note: Press Skip to skip calibration.
The status bar shows
Requirement: The touch display
shows "X-Spect sensor need calibra-
tion. Before starting, place the cover
cap on the appliance."
Place the cover cap on the sensor.
1.
button for
.