Table of Contents
Advertisement
Vax VXL 401 User Guide.qxd:VZL-401 User Guide
With new belt in place, pull and slide brushbar into nozzle
making sure that the brushbar end caps are in the correct
orientation (Fig. 6/6 inset). Rotate brushbar manually to
make sure belt is properly aligned.
Fig.6/6
Replace sole plate onto base of cleaner. (Fig. 6/7).
Fig.6/7
Replace all six (6) screws to secure nozzle guard (Fig.6/8).
Fig.6/8
7. Lightbulb: removal and
replacement
Please contact Vax on 0870 606 1248 for further
advice.
IMPORTANT: Do not attempt to remove or replace the
lightbulb yourself.
All manuals and user guides at all-guides.com
belt or brush bar / lightbulb removal and replacement
13/6/07
18:01
Page 9
8. General maintenance
WARNING: To reduce risk of injury from moving
!
parts - unplug before servicing.
Debris removal/nozzle guard
• Check to see if dirt container is full; empty if needed.
• Plug cleaner in and check to see if there is any suction
at end of hose.
1. Unwrap hose from caddy. Twist and unlock to remove
clogs. Clean out hose with a broom handle. Check access
door on back of cleaner (near hose end). Remove the
seven (7) screws and check for obstruction (Fig.8/1).
Fig.8/1
2. Remove dirt container (Pg. 6) and check dirt container
inlet located on cleaner.
3. Remove nozzle guard by removing the three (6) screws.
Remove obstructions (Refer to Page 8 for belt and
brushbar removal and replacement).
Fig.8/2
Debris removal/Turbo Tool
Rotate locking ring 180
o
and turn Turbo Tool over
(Fig.8/3).
Fig.8/3
Vax Careline
0870 606 1248
LOCKING RING
9
Advertisement
Table of Contents
