Summary of Contents for Vax Ultima Cyclonic VZL-101
Page 1
Vax VZL 101 User Guide.qxd 4/10/07 09:03 Page 1 Vax careline 0870 6061248 Bagless upright Vax model number: VZL-101 Please read carefully before using this cleaner. www.vax.co.uk Always fully extend the mains cable before use. Retain for future reference.
‘off’ position. Hold the vacuum cleaner firmly when damaged cord or plug. If the supply cord or plug is starting and in use. damaged, return the vacuum cleaner to a Vax Authorised Service Agent or suitably qualified IMPORTANT: If the inlet, hose or extension person for examination, repair or adjustment.
Vax VZL 101 User Guide.qxd 4/10/07 09:03 Page 4 www.vax.co.uk 3. How to assemble Carpet height adjuster Turn the carpet height adjuster knob to match the Handle Assembly surface being cleaned (Fig.4/2). Slide wand into slot until you hear a click. Insert screws into holes indicated (Fig.3/1).
Page 5
Vax VZL 101 User Guide.qxd 4/10/07 09:03 Page 5 Vax Careline 0870 606 1248 Any of the accessories can be directly attached to the Floor/Carpet Cleaning end of the extension wand. Move the handle and adjust it to the desired position for...
Vax VZL 101 User Guide.qxd 4/10/07 09:03 Page 6 www.vax.co.uk 5. Dirt container & filter: Separate the filter assembly by removing the foam filter from its plastic housing. Tap the foam filter on the inside removal & replacement of a rubbish bin to remove excess dust and dirt from filter.
Page 7
Vax VZL 101 User Guide.qxd 4/10/07 09:03 Page 7 Vax Careline 0870 606 1248 Fig.5/7 Fig.5/10 Tap the exhaust filter on the inside of a rubbish bin to Replace dirt container remove excess dust and dirt from filter (Fig.5/8). Return dirt container to cleaner. Align slot on bottom of dirt container with tab on cleaner.
Page 8
Vax VZL 101 User Guide.qxd 4/10/07 09:03 Page 8 www.vax.co.uk 6. Belt or brushbar: removal To replace belt or brushbar Slide belt onto motor shaft (Fig.6/4). and replacement TOOL REQUIRED: Phillips screwdriver WARNING: to reduce the risk of injury from moving parts - unplug cleaner before changing belt or brush.
(see fig 8/3) Fig.6/8 7. Lightbulb: removal and Fig.8/2 replacement Please contact Vax on 0870 606 1248 for further advice. IMPORTANT: Do not attempt to remove or replace the lightbulb yourself. 8. General maintenance WARNING: To reduce risk of injury from moving parts - unplug before servicing.
There are Cause: Motor thermostat tripped. over 400 approved Vax Service Agents in the UK. For the Solution: Switch off and unplug the vacuum cleaner. nearest Service Agent, please call the Vax Careline.
Page 12
Page 12 EEC STATEMENT OF COMPLIANCE Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the VZL-101 Ultima Cyclonic Upright is manufactured in compliance with the following Directives: Safety: 2006/95/EC Low Voltage Directive EMC: 2004/108/EC Electromagnetic Compatibility Directive Waste electrical products should not be disposed of with household waste.