Washing Filter A; The Dyson Machine - Dyson v8 User Manual

Washing filter A

Remove your filter
Lift the filter out of the top of the cyclone.
Tap to remove excess dust and debris.
Wash your filter
Hold the open end of the filter under a running tap, until the water runs clear.
Turn the filter upside down and tap it to remove excess water.
Run water over the outside of the filter until the water runs clear.
Squeeze and twist with both hands to make sure the excess water is removed.
Dry your filter
Leave your filter to dry for at least 24 hours in a well-ventilated, warm place.
Do not dry your filter in a tumble-dryer or near a naked flame.
Important: your filter must be completely dry before you put it back into the
machine. Your machine could be damaged if used with a damp filter.
Reassemble your machine
Align the arrow on the top of the filter with the bin release button.
Push down to fit securely in place.
The filter has a top with
five arms that fit onto
the cyclone body.
The filter will only fit
correctly if the arms
are aligned and the
arrow on the top is
pointing towards
the main body of
the machine.