Washing Your Filter - Dyson digital slim User Manual

Washing your filter

For more information and support for your machine go online: https://www.dyson.co.th/en-TH/support/support.
Wash your filter at least once a month to maintain optimum suction power.
Twist off your filter
Twist your filter anti-clockwise and pull it away from your machine.
Tap your filter
Before washing your filter, tap it gently over a bin to remove any loose dust
and debris.
Wash your filter
Wash with warm, running tap water – gently rubbing your filter with your fingers
to remove the dirt.
Fill and shake
Place your hand over one end of your filter.
Fill the filter with warm tap water.
Place your hand over the open end of the filter and shake it firmly to remove
trapped dirt and debris.
Repeat these steps until the water runs clear.
Shake out the water
Empty the filter and shake firmly to remove excess water.
Shake with the filter in both an upward and downward position.
Keep shaking until there's no water coming from the filter.
Dry your filter
Leave your filter to dry for at least 24 hours in a well-ventilated, warm place.
Don't dry your filter in a tumble dryer, microwave or near a naked flame.
Important: your filter must be completely dry before you put it back into the
machine. Your machine could be damaged if used with a damp filter.
Holding the filter
by the hard, plastic
end, tap the other
end over the bin.
Filter held in upright
position, with the wider
end in the palm of
a hand. Water running
from a tap into the
narrower end.
A hand holding the filter with the
narrow end pointing downwards with
droplets of water being shaken from the
filter and again, with the end pointing
downwards shaking water out.
The filter is left to dry
with the pleated filter
end facing upwards.
The filter is located at the
rear of your machine.
Filter with hand over
the open end with
arrows showing
a shaking motion.