Hitachi VM-1800A Instruction Manual page 57

TROUBLESHOOTING
Symptom
Picture does not appear in the
viewfinder.
The camera/recorder cannot go into
the recording mode, even when the
start/stop button is pressed.
Picture is out of focus.
NO OPERATION IS ACCEPTED
Symptom
Power is turned on, but no button operations are
accepted.
PLAYBACK OF PRE-RECORDED CASSETTE
Symptom
"PLAY" button cannot be engaged.
appears on television screen when
selected channel on
(TV is connected to the camera/recorder
using RF converter unit.)
CAMERA RECORDING
you feel a click. Since this
features, reset them again.
Camera/recorder channel
(3 or 4) depending upon the
Check Point & Correction
Remove the lens cap.
`Slide the power switch to
"CAMERA"
Disconnect the AV input cable from
the camera/recorder.
Check the record protect tab on the
cassette.
Make sure that the "FOCUS M" does
not appear in the viewfinder. If it is
displayed, press "Focus" select
button to erase it.
Auto-Focus does not operate if a
special effects filter is attached.
Check Point & Correction
and after about one minute,
push the reset switch gently
using a toothpick, etc. until
erases the date, time and
other customer preferred
Check Point & Correction
"VIDEO" position.
Set the television to the "PLAY" is pressed.
RF channel select switch
of RF converter unit. Set
"AV IN/OUT" switch to
Remove the power source,
Set the "POWER" switch to
No picture
by
57