Speed Change - Makita DHP482 Instruction Manual

Reversing switch action
Fig.6: 1. Reversing switch lever
CAUTION:
Always check the direction of
rotation before operation.
CAUTION:
Use the reversing switch only after
the tool comes to a complete stop. Changing the
age the tool.
CAUTION:
When not operating the tool,
always set the reversing switch lever to the neu-
tral position.
of rotation. Depress the reversing switch lever from the
terclockwise rotation.
When the reversing switch lever is in the neutral posi-

Speed change

Fig.7: 1. Speed change lever
CAUTION:
Always set the speed change lever
fully to the correct position. If you operate the
tool with the speed change lever positioned halfway
damaged.
CAUTION:
Do not use the speed change lever
while the tool is running.
Position of Speed
speed
change lever
1 Low
2 High
Adjusting the fastening torque
Fig.9: 1.
ring 3. Graduation 4.
Graduation
Machine screw
Wood Soft wood
screw (e.g. pine)
Hard wood
(e.g. lauan)
Torque Applicable
operation
High Heavy load-
ing operation
Low Light loading
operation
2.
1 2 3 4 5 6
M4
–
–
torque. Be sure that the speed change lever is set to the
If the tool speed is coming down extremely during the
the operation.
Selecting the action mode
-
CAUTION:
your desired mode mark. If you operate the tool
with the ring positioned halfway between the
mode marks, the tool may be damaged.
CAUTION:
from " " to other modes, it may be a little dif-
-
this case, switch on and run the tool for a second
at the " " position, then stop the tool and slide
the ring to your desired position.
Fig.8: 1.
ring 3. Graduation 4.
• Drilling mode (rotation only)
• Hammer drilling mode (rotation with
hammering)
• Screwdriving mode (rotation with clutch)
action mode changing ring and align the mark that you
fastening torque at 1 and maximum torque at 21.
Before actual operation, drive a trial screw into your
material or a piece of duplicate material to determine
which torque level is required for a particular applica-
7 8 9 10 11 12
M5
3.5 x 22 4.1x 38
3.5 x 22
8 ENGLISH
Always set the ring correctly to
When you change the position
2.
13 14 15 16 17 18
M6
–
4.1x 38
-
19 20 21
–