Installing The Main Grill - Louisiana Grills LG860C Manual

NOTE: Air ventilation and air register vent covers
can be positioned on the front, side or back of the
support structure. Poor/lack of air ventilation in
the support structure will result in damage to your
outdoor kitchen and appliance.
IMPORTANT: Appropriate planning is required to
support the floor of the support structure without
compromising the air supply ventilation and
connection to power. The support structure must be
able to support a minimum of 181.4 kg / 40 0lbs.
• A minimum clearance of 457 mm (18 inches) from
combustible constructions to the sides of the grill,
and 457 mm (18 inches) from the back of the grill
to combustible constructions must be maintained.
Note illustration 1B.
IMPORTANT: If installing an exhaust fan above the
appliance, ensure the fan hood is a minimum of
15cm / 6" wider, on each side, than the front width
of the appliance. As your unit is designed to produce
smoke, it is better to oversize the ventilation system
to compensate.

2. INSTALLING THE MAIN GRILL

Parts Required:
1 x Main Grill (#6)
Installation:
• Using a minimum of two people, lift the base of
the main grill on opposing sides.
IMPORTANT: The unit is heavy. Failure to use
two people could result in injury or damage to
the appliance.
• Place the main grill carefully into the support
structure. The unit should sit level and centered
in the space, unfastened to the support
structure, allowing for easy maintenance.
Allow the power cord to pass through the air
supply ventilation, ensuring that the cord is
not pinched in any way.
TIP: The smoke that exits the rear grill vents
can quickly blacken brick work and other
surfaces. Install a removable backsplash for
easy cleaning.
• Continue installation with Step 3 of the LG860C
Assembly Instructions .
1B
MINIMUM CLEARANCE TO
COMBUSTIBLE MATERIALS
457mm
/ 18 in
457mm
/ 18 in
457mm
/ 18 in
2
Air Supply
Ventilation
750mm
/ 30 in
457mm
/ 18 in
457mm
/ 18 in
Air Exhaust
Ventilation
9