Advertisement
6. Error Indicator
If no fault exists inside the SHP, the light will be off. It will turn red if there is any fault in the product.
Users can go to the app for a fault diagnostic report and reach out to the customer support
representative for help.
7. Power Station Pause/Resume Button
The pause button will physically isolate the 10 load circuits and lock the DELTA Pro. A signal will tell the
DELTA Pros to stop output power.
3.3 Hardware Functions
Power Indicators
If the grid power light is on, the SHP is receiving grid power. If the
DELTA Pro light is green but flashing slowly, it indicates that DELTA
Pro is connected but not ready for output. When the light is static
and green, DELTA Pro is ready for power output.
Power Station Enable/Disable Button
When DELTA Pro is connected using the Infinity Port, press the
enable button once to prepare the unit. Press it again to put DELTA
Pro into sleep mode. Holding down the SHP enable button for 3
seconds will start charging the connected DELTA Pro.
Power Station Pause/Resume Button
DELTA Pro is electrically disconnected from the SHP output when this
button is held down. SHP output is cut. To safely disconnect, the user
should still physically disconnect DELTA Pro from the SHP.
IOT Reset Button and Light
This light is usually off. When the button is pressed once, the light flashes
blue, and SHP Bluetooth allows pairing for one minute. If the user pairs
with the SHP, the light stays blue. Hold down the button for 5 seconds if
the Bluetooth connection needs resetting. If nothing pairs with the SHP,
Bluetooth goes into sleep mode, and the light turns off.
5
Advertisement
