Maintenance - Garmin Tacx NEOBIKE T8000 User Manual

4. Maintenance

How to maintain the Smart bike
•
Regularly check the Tacx Training app (for free in the App store and on Google Play) to see if any
firmware updates are available.
•
Regularly inspect and properly tighten visible bolts.
•
Check the power adapter and cable for any damages with each use. If the adapter or cable is
damaged, contact Tacx Support to order a replacement adapter or cable. Only use the original Tacx
power adapter and cable.
•
Regularly check if the bike is still standing firmly and stable on the floor. Use the adjustable feet
(A5) to level it if required.
•
Regularly check the quality of the handlebar tape and replace if necessary as instructed by the
supplier of the tape.
How to clean the Smart bike
•
Clean the saddle, handlebars and pedals with a moist cloth (with mild cleaning agents).
DANGER: do not operate the trainer while being wet.
• Clean the aluminium disc on the left side of the trainer after each use with a moist cloth and dry
thoroughly.
•
To remove finger prints off the frame, use a degreasing agent like Glassex.
DANGER! Always unplug the power cord before cleaning the trainer and before performing the
maintenance procedures described in this manual.
Never remove any part unless instructed to do so in this manual or by an authorized service
representative. Servicing other than the procedures in this manual should be performed by an
authorized service representative only.
IMPORTANT The safety level of the device can only be guaranteed if it is inspected regularly, for
example for damage, wear, or loose connections. If anything is defective/damaged, contact the Tacx
Support department immediately. In the meantime, the device must absolutely not be used until a
certified service employee has inspected it and performed any repairs.
Please note: do not clean any part of the trainer with abrasive cleaning materials.
- 24 -