Table of Contents
Advertisement
Only fill the water tank with water or with the descal-
▶
ing solution we have recommended.
WARNING ‒ Risk of burns!
The water tank may heat up while the appliance is in
operation.
Wait until the water tank has cooled down from the
▶
previous operation.
Remove the water tank from the tank recess.
▶
Requirement: The water hardness must be set cor-
rectly.
→ "Setting the water hardness", Page 13
Press on the centre of the tank cover.
1.
a The tank cover opens.
Remove the water tank from the tank recess.
2.
Fill the water tank with cold water up to the "MAX"
3.
mark.
Place the water tank into the tank recess and slide it
4.
in fully.
Close the tank cover.
5.
11.7 Refilling the water tank
Notes
¡ The way the appliance responds if the water tank
runs dry when the appliance is in operation
depends on what operating mode it is in:
– Steam operation: The appliance interrupts the
operation. The display shows a message. At the
highest steam setting, a tankful of water will last
around 30-40 minutes; at the lower steam set-
tings, it will last much longer.
– Steam with microwave: The appliance interrupts
the operation. A tankful of water will last around
50 minutes.
– Grill with steam: The appliance continues to oper-
ate using the grill. No message appears on the
display. At the highest steam setting, a tankful of
water will last around 3 hours; at the lower steam
settings, it will last much longer.
¡ Actual times may vary from those specified.
Open the control panel.
1.
Remove the water tank.
2.
Fill the water tank up to the "MAX" mark.
3.
Insert the full water tank and close the control panel.
4.
11.8 After using steam operation
Moisture will remain in the cooking compartment. Care-
fully wipe out the drip trough and the cooking compart-
ment.
Each time you cook using steam, we recommend that
you run the Rinse
cleaning function. Then empty and
dry the water tank and drip tray.
Steam en
19
Advertisement
Table of Contents
