Table of Contents
Advertisement
LED Display
Power up:
Power up phase, please donít move for 10 s;
still no output of servo-signals.
Normal operation: Color
Off / conventional controls (glowing red)
Horizontal mode (glowing
Position mode (glowing green)
Flickering green: not enough contrast,
only horizontal mode but
For checking: switch to ìgreenî mode and hold helicopter
in different distances above ground by hand.
Trim button is pressed, and connect to AUX-Kanal
and assigned (via PC-adaptor)
Setup:
Complete neutral positions learning
Setup process
Fault at selftest
(LED flashes red) No output of servo-signals
(1x)
(2x)
(3x)
(4x)
(5x)
(6x)
(7x)
(8x)
LED dark : undervoltage < 4V
8
indicates the pilot channel position
(step number = count of flashing)
No
(during selftest)
R/C-receiving
Battery < 4V power up
(Do not use for charge monitoring!)
Movement during power up phase, repeat power up
(if necessary wait for temperature change to settle)
Instruments fault or too extreme temperature
Auto trim value at the limit
must be cleared and adjusted mechanically
(reserved)
Unacceptable center divergence at automatic learning
process; at least one channel out of center?
No
at automatic learning process
R/C receiving
orange-
yellow)
no position mode
.
(then power off)
Advertisement
Table of Contents
