Table of Contents
Advertisement
•
The RC module (with cable distributor) supplied in the set must be connected
between the receiver and the servos. It can be attached to the receiver using
Velcro or double-sided tape.
•
(*) If the swashplate moves downward for increase of coll. pitch, swap the
connections of right and left servo(s).
•
You must connect at least the aileron, elevator and collective pitch inputs to
the receiver.
•
The PILOT and AUX connections are optional. Connect these cables to the
receiver output sockets to which the associated transmitter controls (sliders
or switches) of your RC system are assigned.
•
The HeliCommand switches itself on when you switch the receiver on.
Connect the receiver battery directly to the RC module instead to the receiver
(shortest way for servo currents). In case of BEC supply and high servo
currents (e.g. with four digital head servos), we recommend to install an
additional power cable from the BEC controller directly to the battery socket
of the HeliCommand. This cable must not contain a (third) signal wire (or cut
that wire).
•
Unused input cables can be stowed away by turning them through 180° and
connecting them to unused sockets on the receiver or the RC module.
•
Cover the vacant socket on the HeliCommand with adhesive tape to prevent
soiling.
•
LED and sockets are internally supported softly and must remain free to move
in all directions.
•
For extended cable length to the main unit, a ferrite ring is required with at
least 3 loops close to the processor board side.
21
Advertisement
Table of Contents
