Vissani MD1821IM Use And Care Manual page 5

Installation Instructions - ( Top mount freezer )
1
Remove the plug
□ Remove the plug from the inside of the freezer
compartment with a putty knife.
Insert the water inlet tube into the
3
hole
□ Insert the water inlet tube into the hole on the back of the
cabinet. Rotate while inserting until the flat surface of the
inlet tube is tight against the back of the refrigerator.
Secure the water inlet tube to the back of the cabinet
using 2 self drilling screws.
Remove the label and then remove
2
the foam
□ Remove the label covering the ice maker hole on the back of
the cabinet and then remove the foam from inside the hole
using needle nose pliers. Retain the foam for future use.
Water inlet tube and plastic water
4
supply tubing connection
□ Squeeze together and slide the tube clamp over the full tube.
While still squeezing the clamp, insert one end of the plastic
tube into the fill tube as far as it will go and then slide the
clamp downward to capture the full tube in place. Leaks may
result if the plastic tube is not pushed in as far as it will go
and the tube clamp is not in place over the fill tube.
5
Please contact 1-855-847-7264 for further assistance.
HOMEDEPOT.COM