Vissani MD1821IM Use And Care Manual page 13

Installation Instructions
□
Unscrew the plastic cap from the water inlet valve and discard it.
□
Slide a brass compression nut, then a ferrule (sleeve), onto the water supply line.
□
Push the end of the tubing into the water inlet valve as far as it will go or ¼-inch, then slide the ferrule (sleeve) into the valve inlet and
finger tighten the compression nut onto the valve. Tighten another half turn with a wrench. DO NOT overtighten.
□
Secure the water supply line to the back panel of your refrigerator with a steel clamp and screw at the location shown on the
illustration.
□
Coil the excess water supply line (about 2-½ turns) behind the refrigerator and arrange the coils so they do not vibrate or wear against
any other surface.
□
Turn on the water supply at the shutoff valve and tighten any connections that leak.
□
Reconnect the refrigerator to the electric wall outlet.
□
To turn on the ice maker, lower the wire signal arm.
13
Please contact 1-855-847-7264 for further assistance.
HOMEDEPOT.COM