Transport Maintenance - Greyhound 65761 Set Up And Operating Instructions Manual

the compression stroke (when you
start to feel resistance).
f. Disconnect battery cables (if
equipped).
g. Wipe engine with clean cloth.
3. Apply a thin coat of rust preventive oil
to all uncoated metal parts.
4. Cover and store in a dry, well-ventilat-
ed area out of reach of children.
5. Before starting the engine after stor-
age, keep in mind that untreated gas-
oline will deteriorate quickly. Drain
the fuel tank and filter, and change
to fresh fuel if untreated gasoline has
been sitting for a month, if treated
gasoline has been sitting beyond the
fuel stabilizer's recommended time
period, or if the engine does not start
properly.

transport Maintenance

1. BeFore transport, check the Tires
for wear and proper inflation (60 PSI).
2. Prior to Transport and at 500 MILE in-
tervals during trips, check and tighten
the Tire Lug Nuts. Torque from 85 to
90 ft-lb.
3. everY 2,000 to 3,000 MiLes
Travel, lubricate the Hub Assemblies
with a heavy weight bearing grease.
Follow the Bearing Packing Instruc-
tions. After each Hub Assembly is
reassembled, tighten the Castle Nut
until the wheel starts spinning with
slight resistance. Loosen the Castle
Nut about 1/2turn from this point.
Insert a new Cotter Pin through the
Castle Nut and the hole in the axle.
Bend the Pin back, locking it and the
Nut in place.
SKU 65761 For technical questions, please call 1-800-444-3353.
of
Page 18