Start Procedure; Break-In Period; Equipment Operation - Greyhound 65761 Set Up And Operating Instructions Manual

air inlet hole by tightening the Plug,
as shown below.
plug (37)

start procedure

Before starting the engine:
a. Follow the set up instruc-
tions to prepare the equip-
ment.
b. inspect the equipment and
engine.
c. Fill the engine with the prop-
er amount and type of fuel
and oil.
d. read the equipment opera-
tion section that follows.
1. Turn the engine fuel valve to its
"OPEN" position.
2. Turn the engine power switch to its
ON or RUN position.
3. Then, turn the engine choke lever to
its "CHOKE" position. Set the choke
lever in the "RUN" position when
starting a warm engine.
4. Grasp the starter handle, and pull
slowly until resistance is felt. While
holding the handle, allow the starter
rope to rewind slowly. Then, pull the
starter handle with a rapid, full arm
stroke. Once again while holding
the handle, allow the rope to rewind
SKU 65761 For technical questions, please call 1-800-444-3353.
air inlet
o ring (21)
Hole
slowly. Repeat as necessary, until
the engine starts.
5. After the engine starts and warms
up, slowly move the choke lever to its
"RUN" position.
6. IMPORTANT: Allow the engine to run
at no load until warm (1-5 minutes).

Break-in period

1. Breaking-in the engine will help to
ensure proper equipment and engine
operation, and will extend the en-
gine's lifespan. The warranty is void
if the engine is not broken in properly.
The first 20 hours of operation is the
break-in period.
2. During the first 3 hours of use:
• Do not apply a heavy load to the
equipment.
• Do not operate the engine at its
maximum speed.
3. After the first 20 hours of use:
• Change the engine oil.
Under normal operating conditions
subsequent maintenance follows the
schedule explained in the MAINTE-
NANCE AND SERVICING section.

equipment operation

1. Warning! to avoid death or
serious injury; block each side of
both wheels of the Log Splitter before
starting a job.
2. In FIGURE 1, the Rail Assembly is
shown in Horizon tal mode for opera-
tion and travel. In FIGURE 4 the unit
is shown in the vertical position. To
change positions, remove the Hair
Pin Clip (29) and the Push Pin (26).
Page 12