Cleaning, Maintenance, And Lubrication Schedule; After Initial; Operation Hour Period; Every 25 Operation Hours Thereafter - Greyhound 65761 Set Up And Operating Instructions Manual

4. Remove gas fill screen filter. Clean
by blow drying air from outer sides to
inside. Allow to dry completely and
then re-install.
5. Wait for at least one hour before use
to allow all residual fuel vapors to
dissipate. to prevent Fire, do not
start the engine while the smell of
fuel hangs in the air. Remember to
open the fuel valve before restarting
the engine. It may take a little longer
than usual to start the engine be-
cause the fuel needs to refill the fuel
line and new filter.
cleaning, Maintenance, and
Lubrication schedule
note: This maintenance schedule is
intended solely as a general guide.
If performance decreases or if equip-
ment operates unusually, check sys-
tems immediately. The maintenance
needs of each piece of equipment will
differ depending on factors such as
duty cycle, temperature, air quality,
fuel quality, and other factors.
note: These procedures are in addition to
the regular checks and maintenance
explained as part of the regular op-
eration of the engine and equipment.
after initial 20 operation Hour period:
a. Change engine oil.

every 25 operation Hours thereafter:

a. Clean/replace air filter element.
b. Inspect/clean spark plug.

every 50 operation Hours:

a. Change engine oil.
b. Replace fuel filter (if equipped).
SKU 65761 For technical questions, please call 1-800-444-3353.

every 100 operation Hours:

a. Replace spark plug.
b. Replace air filter element.
note: All maintenance procedures sched-
uled for 25, 50, and 100 operation
hours should be performed at least
yearly.

every 300 operation Hours:

a. Clean fuel tank and carburetor.
b. Clean carbon build-up from combus-
tion chamber.

storage

1. Wait for engine to cool, then wipe the
Log Splitter with clean cloth.
2. When the equipment is to remain idle
for longer than 20 days, prepare the
engine for storage as follows:
a. Change engine oil and empty fuel
tank.
b. Either leave fuel tank empty or
refill fuel tank with fresh unleaded
gasoline mixed with a fuel stabilizer
intended for long term engine stor-
age (not included). After filling, run
engine for about 5-10 minutes to cir-
culate the treated gasoline through
the carburetor. Wait for engine to
cool before proceeding.
c. Clean out area around spark plug.
Remove spark plug and pour one
tablespoon of engine oil into cylinder
through spark plug hole.
d. Reinstall spark plug, but leave spark
plug wire disconnected.
e. Pull recoil starter to distribute oil in
cylinder. Stop after one or two revo-
lutions when you feel the piston start
Page 17