Advertisement
Before adjustment, remove the panel assembly. Then turn the handwheel and raise the needle to its highest
position.
1. Raise the presser lever and loosen the screw securing the presser bar winding.
2. To adjust the height of the presser bar, raise the presser lever, and, at the point where the presser bar is
horizontal, raise or lower it until the first step is 4.8 ~ 5.0 mm above the needle plate. Make sure that the
presser lever does not come in contact with the upperlooper when it has been raised to the height of the
first step. Check also to make sure that the needle descents of the presser bar are not noticeably out of
alignment with the needle slots of the needle plate.
3. After the adjustment has been completed, tighten the screw securely that holds the presser bar winding in
place.
www.promelectroavtomat.ru
- 12-
Advertisement
