ABI Attachments ABI-BS-GD-339 Owner's Manual page 12

Initial Setup (cont'd)
Slide flat plate on flow control assembly
into grooves on mobile shutter attached
to the bottom of the hopper.
Rotate flow control assembly bracket
up and behind curved guard.
Fig 20.
Rotate curved guard up or down as needed to get
threaded hole in flow control assembly bracket
centered in slot of curved guard.
Fig 22.
Fully tighten both nuts securing curved guard to main
support frame (from Fig 6) once flow control bracket
hole is centered in slot on curved guard.
Fig 25.
Re-thread the flow control adjustment knob and
washer thru the curved guard slot and into the
threaded hole on the flow control assembly bracket.
Visit: www.abisupport.com
Fig 21.
Curved guard.
Fig 23.
Fig 26.
Fig 28.
Fig 29.
20mm washer
Fig 31.
12
Fig 27.
28mm shim
axle sha
The long tube portion of
the hub (with the small
hole going thru the side
of the hub) faces inward
toward the gearbox on
the axle.
Fig 30.
bent cotter pin
M6x45 hex head
washer and
bolt and washer.
M6 locknut.