Epson RC+ 7.0 Manual page 15

4. Transport and mounting
Transport
The weight of the linear feeder is taken from the table described in 1. Technical data.
Mounting
The linear feeder should be mounted on a stable substructure (available as an accessory part)
at the place where it is used. The substructure must be dimensioned in a way that no
vibrations of the linear feeder can be carried away.
The following table will give you a summary of the bore data of the various types:
Linear feeder type
SLL 400 – 400
SLL 400 - 600
Make sure that the linear feeder cannot come into contact with other devices during
operation.
For further details on the control unit (bore plan, etc.), refer to Hardware (Hopper
Controller).
Part Feeding 7.0 Hopper & Hopper Controller Rev.5
Take care that the linear feeder cannot dash against other things
NOTE

during transport.
Length in mm
200
300
Be careful not to get hand, fingers, or feet caught and/or have
equipment damaged by a fall of the hopper or the hopper-
controller. When working, please wear Protective equipment
WARNING
such as safety shoes.
4. Transport and mounting
Width in mm Mounting screws
140 M8
220 M6
9