3. Information for starting
DANGER
3.1 AC Power Cable
WARNING
Item
AC power cable (2 wires)
Protection ground wire
Power cable width
Cable length
Cable end
26
At initial starts or starts after repair work or exchange of control
units/oscillating drives the minimum output should be set at
the control unit before switching on the device. When bringing
up the output it must be taken care for correct function.
■ The work should be done by a person with that specialized
knowledge and skills.
■ Make sure AC power ground cable (Green/yellow) connect to the
earth terminal of power supply system. There is a risk of electric
shock if this is not done properly.
■ Use disconnecting device for power connection cable and do not
connect it directly to the factory power supply.
■ Select disconnecting device meets the safety standards of each
country.
50Hz Specification
L: Brown, N: Light blue
Green/Yellow
1mm
2
1.5m
The terminal ferrule length 8mm
Part Feeding 7.0 Hopper & Hopper Controller Rev.5
60Hz Specification
L: Black1, N: Black 2
Green/Yellow
AWG18
1.5m
The terminal ferrule length 6 mm