Table of Contents
Advertisement
2.2
Safety regulations for the method of operation
Building Technologies
Fire Safety & Security Products
National standards, regulations and legislation
Siemens products are developed and produced in compliance with the relevant
European and international safety standards. Should additional country-specific or
local safety standards or regulations concerning the project planning, assembly,
installation, operation or disposal of the product apply at the place of operation,
then these must also be taken into account together with the safety regulations
mentioned in the product documentation.
Electrical installations
WARNING
Electrical voltage
Electric shock
Work on electrical installations may only be carried out by qualified
electricians or by instructed persons working under the guidance and
supervision of a qualified electrician, in accordance with the electrotechnical
regulations.
If possible de-energize products on which commissioning, maintenance or
repair work is being undertaken.
Lock areas that have been de-energized so that they cannot be switched back
on by mistake.
Label connection terminals with an external source of voltage using a
'DANGER external source of voltage' board.
Separately route feeders to products and fuse these with their own, clearly
marked fuses.
Fit an easily accessible disconnecting device in accordance with IEC 60950-1:
2005 outside of the installation.
Earth according to local safety regulations.
Assembly, installation, commissioning and maintenance
If you need aids like a ladder, the aids must be safe and suitable for the work to
be carried out.
When starting the fire control panel ensure that unstable statuses cannot occur.
Ensure that all points listed in the following section 'Testing the product
operability' are observed.
You may only set controls to normal function when the product operability has
been completely tested and the system has been handed over to the customer.
Safety
9
A6V10201150_a_en_--
05.06.2008
Advertisement
Table of Contents
