Data Line Transient Protection - NCR RealPOS 60 Site Preparation Manual

A-2

Data Line Transient Protection

The nature of the transient phenomenon may extend to the data communication lines
connected to this equipment. It is the responsibility of the customer to install and
connect a data line transient suppression system to correct or prevent any deficiencies.
Such systems must meet the following minimum requirements:
• Be of the voltage limiting type and must self-recover after passage of the transient.
• Must be designed to avoid signal degradation for the given interface they are
• Be installed in accordance with all applicable local, state, and national electrical codes
The following product offerings are available from NCR Site Preparation Services:
• UPS -Uninterruptible Power Systems
• Line Conditioners / Filters
• Transient Voltage Surge Suppressors
attached to.
and regulation.
Note:
NCR provides a full line of both AC power and data line transient surge
suppressors to protect your RealPOS system and reduce downtime and extend the
life of the RealPOS Retail Solution. For sizing and product information, please call
NCR Site Preparation Services at 800-257-0458.
• Provides battery backup for power outages and brownouts.
• Includes AC and data line surge protection.
• If needed, certain models provide basic voltage regulation.
• Small size provides easy installation.
• Incorporates an Isolation transformer or filter that provides 100% isolation from
disturbances on the incoming AC power line.
• Removes EMI/RFI noise that causes equipment lockups.
• Reduces common mode noise issues and surges/transients.
• Significantly reduces POS downtime and component failure.
• Provides protection from catastrophic AC surges/transients.
• Provides data line protection from catastrophic surges that can migrate onto the
data line and network.
Transient Protection