Cisco mds 9000 family command reference - cisco mds san-os release 3.0(1) through 3.3(1a) (ol-16217-01, april 2008) (1550 pages)
Summary of Contents for Cisco Meraki MS350 Series
Page 1
MS350 Series Installation Guide About this Guide This guide provides instruction on how to install and configure your MS350 series switch. This guide also provides mounting instructions and limited troubleshooting procedures. For more switch installation guides, refer to the switch installation guides section on our documentation website.
Back Panel MS350 Series back panel Factory Reset Button If the button is pressed and held for at least five seconds and then released, the switch will reboot and be restored to its original factory settings by deleting all configuration information stored on the unit. Ports and Status Indicators The MS uses LEDs to inform the user of the device's status.
Item Function LED Status Meaning Restore Restore button to clear switch IP and local con Management Interface Green Connected, used for easy access to the local s Stack Ports Stack Cables are connected here Redundant Fans Green Active and operational Redundant Power Supplies Green Active and functional power supplies...
Note: MS350 also comes with a half meter stack cable. If using a 640WAC or 1025WAC power supply, it will require a C15 power cable. Safety and Warnings These operations are to be taken with respect to all local laws. Please take the following into consideration for safe operation: •...
3. If the unit requires an upgrade, the power LED will begin blinking white until the upgrade is complete, at which point the LED will turn solid white. You should allow at least a few minutes for the firmware upgrade to complete, depending on the speed of your internet connection.
If you are still experiencing hardware issues, please contact Cisco Meraki support by logging in to dashboard and using the Help option near the top of the page, then opening and email case or calling using the contact information on that page.
Page 8
• The equipment is subject to installation and maintenance by specialists with the appropriate qualifications, sufficient specialized knowledge, and skills. • Rules and conditions for the sale of equipment are determined by the terms of contracts concluded by Cisco or authorized Cisco partners with equipment buyers.