Advertisement
Turn over the assembled chair bucket and secure the swing arms on
U-shaped fitting (D) to the bottom tube of left arm (A1) and right arm
(A2) with 4 screws (J), and 4 nuts (H) with allen wrench (K) and
wrench (L).
NOTE: PLEASE FIX TWO SCREWS IN DIAGONAL POSITION TO KEEP
THE BALANCE THEN FIX THE OTHER TWO SCREWS.
Push the top plate on the base (E) with different position to make the
Push the top plate on the base (E) with different position to make the
holes open for ready assembling. Connect the 4 screws (J) through
the holes of the plate on the base (E) and the holes on the tube of U-
shaped fitting (D) with 8 washers (G) , 4 spring washers (F) and 4 Nuts
(H) by using allen wrench (K) and open end wrench (L) .
NOTE: THIS STEP IS VERY IMPORTANT. DO READ THE
INSTRUCTION AND DIAGRAM CAREFULLY.
STEP 5
B
STEP 6
E
D
A2
D
C
A1
J
G
G
F
H
Advertisement
