Connecting Speakers - Vanguard Dynamics VAIL CAST User Manual

CONNECTING SPEAKERS

The VAIL Cast can be connected to up to two pairs (4 total) of speakers. To connect the speaker wire
first unplug the 4-connector speaker plug from the VAIL Cast. Strip the speaker wire you will be using
just long enough to fit into the connector. This will assure that there are no shorts between the wires.
Make sure the screws are open then place the appropriate (R, L, + or -) stripped wire into the opening
and firmly screw it down in place. If you will be installing more than one pair of speakers, you will be
operating the speakers in "Parallel".
input and two connected to the left input.
There is not enough space on the connector to directly accommodate two pairs of speaker wire so you
will have to split them after the connection if you will be placing both pair of speaker wires at the VAIL
Cast.
IMPORTANT: If you will be using 2 pairs of speakers place the switch in the 4ohm position. If you will
only be using one pair of speakers leave the 4ohms/8ohms switch in the factory setting of 8ohms.
MOUNTING VAIL CAST INTO THE WALL
IMPORTANT: If you are not familiar with cutting drywall and installing products, please contact us so that
we can pair you with an authorized dealer that can assist you. As mentioned above please assure that
you will have a good Wi-Fi connection at the chosen location or use an ethernet cable before cutting the
drywall. The VAIL Cast includes a bracket that allows it to be mounted into a 2 Gang Low Voltage
Mounting Bracket, hereafter called Mounting Ring. While we have tested the bracket with a wide vari-
ety Low Voltage Rings, please test yours to make sure the VAIL Cast Bracket will slide into and align with
the Mounting Ring you have selected before installing. The bracket will not fit into a 2 Gang Box.
OVERVIEW OF PARTS NEEDED
VAIL CAST Wall Bracket
This means you will have two speakers connected to the right
4 Screw for Securing Bracket
Upper
Mounting
Tabs
Lower
Mounting
2 Screws for Securing Upper
Tabs
Mounting Tabs to VAIL CAST
Phone : (866) 834-6321
Email: info@vanguarddynamics.com
www.vanguarddynamics.com
to Low Voltage Ring
Example of 2-Gang Low
Voltage Ring Needed