Vanguard Dynamics VAIL CAST User Manual page 13

V AIL
1. Read these instructions – All the safety and operating instructions should be read before this product is operated.
2. Keep these instructions – The safety and operating instructions should be retained for future reference.
3. Heed all warnings – All warnings on the appliance and in the operating instructions should be adhered to.
4. Follow all instructions – All operating and use instructions should be followed.
5. Do not use this apparatus near water – The appliance should not be used near water or moisture – for example, in a wet basement
or near a swimming pool, and the like.
6. Clean only with a dry cloth.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce
heat.
9. Do not defeat the safety purpose of the polarized plug, if provided. A polarized plug has two blades with one wider than the
other. The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electri-
cian for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at the plugs, convenience receptacles, and at the point
where it exits from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Unplug the apparatus during lighting storms or when unused for long periods of time.
13. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such
as; the power-supply cord or plug is damaged, liquid has been spilt or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not
operate normally, or has been dropped.
14. CAUTION: Servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock, do not
perform any servicing other than that contained in the operating instructions unless you are qualified to do so.
FCC STATEMENT
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. This device complies with Part 15
of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radiofrequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help. Only operate the device in accordance with the instructions
supplied. This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the
possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less
than 20cm (8 inches) during normal operation. Changes or modifications not expressly approved by the party responsible for
IC STATEMENT
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1)
this advice may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device. The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and
compliance with RSS-102 RF exposure. Users can obtain Canadian information on RF exposure and compliance.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This Class B digital apparatus
complies with Canadian ICES-003.
This Category ll radiocommunication device complies with industry Canada Standard RDD-310.
TRADEMARK AND LICENSE
Use of the Works with Apple badge means that an accessory has been designed to work specifically with the technology identified
in the badge and has been certified by the developer to meet Apple performance standards. Apple, iPad, iPad Air, iPad Pro, iPhone
and AirPlay are trademarks of Apple Inc., registered in the U.S. and other countries. To control this AirPlay 2– enabled speaker,
iOS 11.4 or later is required.
Google, Android, Google Home and Chromecast built-in are trademarks of Google LLC. Amazon,Alexa and all related logos and
motion marks are trademarks of Amazon Inc. or its affiliates.
Use your phone, tablet or computer as a remote control for Spotify. Go to spotify.com/connect to learn how.
The Spotify Software is subject to third party licenses found here: https://www.spotify.com/connect/third-party-licenses.
The device must be able to be awakened by the Google service in various power modes, the LS9X module and the Ethernet module in the device
needs to be in working mode all the time, so the device power consumption will be greater than 2W when the device enters the network standby.
Based on Vail Cast function design requirement, the wireless or Ethernet module (LS9X Module) must keep searching and working function on
Google Cast and with Alexa function. So it cannot enter normal standby mode and network standby due to the features of the product.
Important Safety Instructions