GE TOP-FREEZER 16 Owner's Manual And Installation Instructions page 12

1
INSTALLING THE WATER LINE
7
CONNECT THE TUBING
TO THE REFRIGERATOR
NOTES:
• Before making the connection to the refrigerator, be
sure the refrigerator power cord is not plugged into the
wall outlet.
• We recommend installing a water filter if your water
supply has sand or particles that could clog the screen of
the refrigerator's water valve. Install it in the water line
near the refrigerator. If using GE SmartConnect
Refrigerator Tubing kit, you will need an additional tube
(WX08X10002) to connect the filter. Do not cut plastic
tube to install filter.
Remove the access cover.
Remove the plastic flexible
cap from the water valve
(refrigerator connection).
Place the compression nut and ferrule (sleeve)
onto the end of the tubing as shown. On GE
SmartConnect Refrigerator Tubing kit,
™
the nuts are already assembled to the tubing.
Insert the end of the tubing into the water valve
connection as far as possible. While holding the tubing,
tighten the fitting.
For plastic tubing from a GE SmartConnect
Refrigerator Tubing kit, insert the molded end
of the tubing into the shutoff valve and tighten
compression nut until it is hand tight, then
tighten one additional turn with a wrench.
Overtightening may cause leaks.
Fasten the tubing into the clamp provided
to hold it in a vertical position. You may need
to pry open the clamp.
1/4" Copper
Tubing
Refrigerator Connection
Reattach the access cover.
Installation Instructions
™
™
Tubing Clamp
1/4" Compression
Nut
Ferrule (sleeve)
SmartConnect
™
Tubing
12
(CONT.)
8
TURN THE WATER
ON AT THE
SHUTOFF VALVE
Tighten any connections
that leak.
9
PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the wall.
Push the refrigerator back to the wall.
START THE ICEMAKER
10
On power switch models, set the icemaker power switch
to the l (on) position. On feeler arm models, move the
feeler arm to the ON (down) position. The icemaker will
not begin to operate until it reaches its operating
temperature of 15°F (–9°C) or below.
It will then begin operation automatically.
Power
switch
Power switch model
Feeler arm model
NOTE: In lower water pressure conditions, the water
valve may turn on up to 3 times to deliver enough water
to the icemaker.
Feeler Arm in the
STOP (up) position
Feeler Arm in
the ON (down) position