Product Description - Xytronic LF- 8800 Instruction Manual

delayed switch feature has been incorporated for the unit that allows the pump to
continue sucking for 1.5 seconds after the actuator switch is released.
■ LIGHTWEIGHT SOLDERING IRON: Ergonomic mini handle that stays cool and
prevents operator fatigue.
■ ENERGY SAVER MODE: If the station has been idle for 20 minutes, the energy
saver feature will automatically engage, the temperature goes down to 150℃ from the
set temperature. Activating the solder/desolder wands will disengage the power saving
feature and the unit will immediately ramp up to the preset temperature. When over 40
minutes without operation the main power will be switched off to "sleep mode" which
cuts power consumption and extends tip life.
Please note: You have to switch off the unit first and then switch "ON" again to
commence work when the unit goes to "Sleep" mode.
■ IRON WORKING OPTION: Both soldering, desoldering irons can be used at the
same time. You can also set by pressing keys " SET + ▲" when you only use soldering
or desoldering iron. At this time, the iron which you set will enter the power off suspend
status. It means that the heater power is cut off. If press "▼"then the heater power will
be on.
■ OPTIONAL SMD TWEEZERS : The additional feature is specially designed for SMD
chips, SOT, Flat pack ICs' etc. reworking. TWZ90 Tweezers can be interchangeable
with soldering iron as an option. Be sure before proceeding this operation, the main
switch must be "OFF" to avoid any damage to the unit.
LF-8800 operates with the high power 32V/100W output that is specially designed for
lead-free soldering/desoldering works to meet RoHS requirement. This unit built in a
self-contained, oil free, maintenance free, and quiet running vacuum pump which is
electronically controlled and will not overload with continuous use, eliminating the need
for additional shop air. The vacuum pump provides up to 50cm/Hg (20in/Hg) suction power,
activated by a push button switching circuit located on the desoldering wand. Internal
solder collector in handpiece is quickly and easily removed for cleaning. The inside mesh
aluminum cooling strip has better solder chip adherence. Also the ventilation slots makes
for a cooler handle, improving operator comfort.
LF-8800 incorporates electronic circuitry which enables the user to set the soldering tip
temperature from 150℃ (302℉) through 480℃ (896℉) and desoldering tip temperature
from 300℃ (572℉) through 450℃ (842℉) without changing tips or heating elements.
Also, with digital display readout and pressing keys on the front panel get clear vision and
comfortable setting. The temperature is maintained within ±3℃ (±6℉) of its operating
temperature by a thermocouple sensor to ensure maximum temperature as close to the
Dane kontaktowe:
NDN - Zbigniew Daniluk tel.: (22) 641-15-47
ul. Janowskiego 15
e-mail: ndn@ndn.com.pl
02-784 Warszawa
NIP: 521-044-00-73

PRODUCT DESCRIPTION

2
Dystrybucja i serwis