Table of Contents
Advertisement
Configuration
To set up the PCL-843's configuration using the software utility,
follow the procedures below:
Step 1. Ensure that jumper JP4 (pins 3 and 4) is open
Step 2. Run the SETUP.EXE file located in the root directory of the
software utility diskette. The software will then bring you to
the software setup screen as shown below.
ESC
Step 3. For initial setting up of you card select "S" for setup. The
other option "D" is for later diagnostic testing.
Step 4. When you select setup the screen shown on the next page will
appear. Move the highlight bar to the setting required and
press "ENTER" to select the options.
12
PCL 843
User's Manual
using
16-bit Etherboard Setup/Diagnostic Utility V2.12
Current Configuration
Node Address
I/O Address
Interrupt Request
Remote Boot ROM
Mode
Press S to run SETUP
Press D to run DIAGNOSTIC
Press Esc to exit
Setup
Diagnostic
Setup/diagnostic main screen
software
: 00 C0 6C 51 14 26
: 300H
: IRQ 3
: DISABLE
: MODE 0
Advertisement
Table of Contents
