Card Configuration; Jumper Settings - Advantech PCL-843 Manual

Card configuration
Configuration of the PCL-843 can be done with jumpers or via the
software utility. Only five parameters need to be set, these are:
PCL 843 Jumper Options
Selection
Software/Jumper Selection
I R Q
I/O Address
Boot ROM Address
Mode Selection
Please refer to the diagram on the previous page for jumper locations.
Using the software to configure the card is covered in the software
section of this chapter.
Jumper
This section tells how to set the jumpers to configure your card. It
gives the card default configuration and your options for each jumper.
How to set jumpers
You configure your card to match the needs of your application by
setting jumpers. A jumper is the simplest kind of electric switch. It
consists of two metal pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect them. To "close" a
jumper you connect the pins with the clip. To "open" a jumper you
remove the clip. If you have any doubts about the best hardware
configuration for your application, contact your local distributor or
sales representative before you make any changes.
8 PCL 843 User's Manual
settings
Switches/jumpers
J P 4
J P 2
J P 1
J P 3
J P 4
Default
Jumper Setting
I R Q 3
3 0 0 H
Disable
Mode 0