Fan Switch; Vent Control; Temperature Limiting; Air Direction - GE AJCS 06 LZ Owner's Manual

Cooling/Heating Descriptions
FOR NORMAL COOLING
OR HEATING
Select HIGH COOL or HIGH
HEAT with the thermostat
at mid point.
3
3

Fan Switch

On Heat/Cool models, the fan switch lever is
located in a hole through the control panel. To
reach it, you need to remove the front grille.
Use a small screwdriver to change the setting.
Cool only models have a rocker switch on the
front of the control box.
When set at CYCLE (down) the fan cycles on and
off when cooling or heating. When set at CONT
(continuous, up) the fan runs all the time. The
unit is shipped in the CONT setting.
4

Temperature Limiting

Limiting the maximum and minimum settings
prevents users from turning the control to the
extreme heat or cool positions.
The normal range of the temp control is approx-
imately 60 F to 85 F. The control range may be
narrowed by the use of the temperature limiting
screws located behind the control panel.
FOR MAXIMUM COOLING
Select HIGH COOL with the
thermostat at maximum
cool.
Features and appearance may vary.
Limits Limits
heat cool
temp temp
Each position equals
approximately 3 F.
4
FOR MAXIMUM HEATING
Select HIGH HEAT with the
thermostat at maximum
heat.
OPEN
CLOSE
5
5

Vent Control

The vent control is located behind the front
grille. When set at CLOSE , only the air inside the
room will be circulated and conditioned. You
may adjust it by removing the front grille. When
set at OPEN , some inside air is exhausted out-
side.
NOTE: The vent lever is taped in the CLOSE
position when it leaves the factory. Remove
the tape before using.
6

Air Direction

Horizontal louvers on the front grille let you
control the air direction up and down.
Remove the front grille to adjust the vertical
louvers side-to-side to direct the air left or right.
FOR QUIETER &
NIGHTTIME COOLING
Select LOW COOL or LOW
HEAT with the thermostat
at mid point.
6
5