GE AJCS 06 LZ Owner's Manual page 11

3
Remove the Air Conditioner From the Case
1 Remove the front grille. See the Care and
Cleaning section.
2 Find the locking plate located on the front
left side.
3 Remove the screw and the locking plate to
unlock the air conditioner.
Locking
plate
Remove
screw
4 Remove and discard the shipping screw on the
back of the air conditioner to allow removal of
the air conditioner from the case.
Remove
screw
5 Pull the bottom corners of the air conditioner
and slide it out of the case.
6 Remove the shipping pad inside the air
conditioner next to the compressor.
Shipping pad
7 Remove the rear grille that is taped to the back
of the case. Remove the packet of screws taped
to the back of the grille. While holding the
grille at a 45° angle, insert it into the clips at
the top of the case and push the bottom in.
Keep slight upward pressure on the grille until
it fits flush with the bottom of the case.
If attaching the grille from the outside of the
case use the 2 long screws.
Insert the 2 long screws on the outside
If attaching the grille on the inside of the case
use the 2 short screws.
Insert the 2 short screws on the inside
Clips
11