Figure 5-11. Vor Discrete Inputs Page (Gns 530 Only); Figure 5-12. Vor/Loc/Gs Cdi Page (Gns 530 Only) - Garmin GPS GNS 530 Installation Manual

5.2.10 VOR DISCRETE INPUTS Page
(GNS 530 Only)
Select the VOR DISCRETE INPUTS Page (see Figure 5-
11). This page allows you to verify the operation of an
external VLOC transfer switch that may be present in the
installation.
Selection
REMOTE XFR
5.2.11 VOR/LOC/GS CDI Page (GNS 530 Only)
Select the VOR/LOC/GS CDI Page (see Figure 5-12).
This page allows you to verify and calibrate the CDI
outputs,
both lateral (LAT) and vertical (VERT) from the
VOR/LOC/Glideslope receiver, as well as the OBS
resolver input to the VOR receiver. It also allows you to
select the format for DME tuning data. Using the controls
on the GNS 530 front panel, make the selections below
and verify the interfaces as appropriate:
The LAT, VERT, and SELECTED COURSE configurations only apply to installations where a CDI/HSI is
connected to the VOR/LOC/GLIDESLOPE pins on connector P5006.
CDI (LAT/VERT)
Selection
Max left/up
Full left/up
Center
Full right/down
Max right/down
FLAG (LAT/VERT)
Selection
Hide
View
S-FLG (LAT/VERT)
Selection
Hide
View
500 SERIES INSTALLATION MANUAL
P/N 190-00181-02
Verify That:
The box is filled in while a remote VLOC transfer switch is pressed.
NOTE
Verify That:
The CDI is "pegged" to the left/up.
The CDI is deflected full scale to the left/up.
The CDI is centered.
The CDI is deflected full scale to the right/down.
The CDI is "pegged" to the right/down.
Verify That:
The LAT/VERT flag is hidden.
The LAT/VERT flag is in view.
Verify That:
The LAT/VERT superflag is hidden.
The LAT/VERT superflag is in view.
Figure 5-11.
VOR DISCRETE INPUTS Page
Figure 5-12.
VOR/LOC/GS CDI Page
Page 5-11
Rev G