Page 1
Odstock Medical Limited USER INSTRUCTION MANUAL OML LINQ Model: OML LINQ Model Version: 1.0 Software: V1.2 To be used in conjunction with the OML Stimulator Instruction Manual www.odstockmedical.com...
Table of Contents Introduction and Key Features Precautions Attaching the Holder Removing the Holder Installing a Battery Joining Instructions Installing a Wired Footswitch Use and Care Instructions Miscellaneous Warranty Components and Accessories Specification and Operating Environment Fault Finding Description of Symbols Manufacturer Details...
Pace XL. Uniquely the OML ® LINQ can have two Wired Footswitches attached allowing for additional triggering options (refer to the OML LINQ : Addendum for Clinicians). The OML LINQ has been designed to allow the user to set the device up with their wireless stimulator. However some functions identified in this manual require a clinician to set them up.
Odstock Medical Limited. Doing so will invalidate the warranty. 9. The OML LINQ must only be used with Odstock Medical Ltd products. 10. Before use check that the OML LINQ has no visual signs of damage.
Page 5
12. Like all wireless devices the OML LINQ should not be used in areas where wireless is prohibited (e.g. aircraft). The OML LINQ should be carried in luggage with the battery removed from the device. Revert to using the stimulator with a Wired Footswitch.
Attaching the Holder 1. Ensure that the OML LINQ is positioned correctly in the Holder. 2. Push the OML LINQ into the Holder ensuring that both arms click into place into the slots on the side of the device. Arms...
4. If present then remove the old battery. 5. Install the new battery with the positive side of the battery facing out from the OML LINQ . If installed correctly the blue light will flash once (please refer to image C).
5. Bring the stimulator and OML LINQ close to each other. 6. After a few seconds the stimulator will indicate that joining has been successful and the blue light on the OML LINQ will stop flashing. 7. Your OML LINQ is now joined.
Page 11
Flashing Blue Light Joining Button ‘Joining in Progress’ ‘Single Press’...
Installing a Wired Footswitch Prior to inserting the footswitch plug into the socket make sure that there is no debris in the socket of the OML LINQ Insert the Odstock Medical Wired Footswitch into either socket of the OML LINQ .
Normal Use Normal use of the OML LINQ is defined as wearing the device in the Holder mounted to either a shoe or sock. Alternatively, the OML LINQ can be used without the Holder and placed directly in a sock.
If this occurs a small movement of the foot or force on the Wired Footswitch will wake up the OML LINQ Turning off the OML LINQ There is no off switch on the OML LINQ .
Warranty OML LINQ is warranted for a period of one year from the date of sale or fitting. The following exceptions apply: • Footswitches are warranted for a period of one month • Leads and batteries Should the unlikely event of any failure of the device occur during the warranty period, the device should be returned to Odstock Medical Limited for inspection.
Specification and Operating Environment Specification Battery VARTA, Lithium Coin Cell, CR2430, 3V Battery Life >3 weeks Dimensions 49 x 42 x 14mm Weight Materials ABS, Polycarbonate, Rubber Coating Without Holder Without battery Operating Environment Operating Temperature 0 to +45 Storage and Transport Temperature -25 to 70 Operating Relative Humidity 15 to 93%...
CE mark declares that the product meets the requirements of applicable EC directives. Use by date in the format of year/month. The OML LINQ contains an RF transmitting device. Protected against solid foreign objects of greater than 2.5mm and dripping water at an angle up to 15 degrees.
FCC public notice DA00. 107. Transmitter. Quality of The OML LINQ™ is designed and tested to service have a response rate of less than 100ms latency depending on system configuration after the detection of a heel event.
Page 21
(such as home routers), the user should turn off the system and move away from the interfering equipment. Please refer to fault finding. Like all radio telemetry devices the OML LINQ™ should not be used while flying. Remove the battery to turn off the OML LINQ™ (page 8).
Page 22
Electromagnetic Compliance Electromagnetic Emissions The OML LINQ™ was tested a lead of the maximum length (footswitch – 0.6m) in a system with 2 ODFS® Pace XL and an OML Remote. Manufacturer’s declaration of electromagnetic emissions The OML LINQ™ is intended for use in the electromagnetic environment specified below.
Page 23
Electromagnetic Compliance Manufacturer’s declaration of electromagnetic immunity The OML LINQ™ is intended for use in the electromagnetic environment specified below. The customer or user of the OML LINQ™ should assure that it is used in such an environment. Immunity test...
Page 24
If the measured field strength in which the OML LINQ™ is used, exceeds the applicable RF compliance level above, the OML LINQ™ should be observed to verify normal operation. If abnormal performance is observed, additional measures may be necessary, such as re-orientating or relocating the OML LINQ™.
Page 25
The OML LINQ™ is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The customer or the user of the OML LINQ™ can help prevent electromagnetic interference by maintaining a minimum distance between portable and mobile RF communications...
Page 26
Regulatory Representatives Odstock Medical Limited is based in the United Kingdom. Odstock Medical Limited uses external bodies as representatives where required by local regulations. Any adverse incidences or regulatory problems should be reported via local representative. If in doubt please contact Odstock Medical Limited for advice.
Page 27
Notes Local contact information may be placed here.