Related Manuals for Metabo PW601
Summary of Contents for Metabo PW601
- Page 1 Shanghai Pengwang Machinery Co., Ltd. Address：Building 8, No.1098, Chuansha road, Pudong New Area, Shanghai Sales phone: +86 15801732387 PW601 Metabo Extruder Manual...
- Page 2 General Please read this manual carefully before using this machine, and retain it for future reference. This plastic extrusion welding machine pioneered using of the function of double independent heating systems, 360-degree rotating welding head, motor cold start protection, which is applicable to welding HDPE,PE,PP and other hot melt materials. It plays its most characteristic especially for welding PE membrane.
- Page 3 Ⅱ. Technical Parameter Voltage 220V Frequency 50Hz Motor Power 1300W Hot Air Power 3400W Hot Air Temperature. 20-650℃ Extruding Temperature 300-420℃ Adjustable Preheating Temperature 200-400℃ Rod DIA Φ3.5-4.5mm Welding Speed 1.8-3.6kg/h Welding Material HDPE/PP/PVC/PVDF Main Components and Name Ⅲ. 1. Heating Element 6.
-
Page 4: Operation
Operation Ⅳ. 1. Put the extruder on the shelf and install the handle, connect the power supply. 2. Turn on the hot air gun power switch, then adjust the temperature control knob, and set the temperature to the required figure(during preheating you can adjust to the highest temperature, when formal operation can adjust to the appropriate temperature). - Page 5 After feeding welding rod the rotation rates of motor will become heavier, if it becomes very difficult, please stop immediately, may be the screw heating time is too short or the temperature is not high enough. Or the temperature is so high that lead to the cut solder particle has been melt and clinging to the cutting blade to cause the plugging before it falls into the extrusion gun body.
-
Page 6: Product Warranty
Precautions for Use (The Content on the Label) 1. Preparation stage: Preheating the extruder on the shelf, carefully check the power plug and prevent it from falling off. 2. Extrusion gun preheating stage: Preheating the extruder for 3 minutes. Take the softened residue can be clip out with a nipper plier as standard. - Page 7 b. User intentionally damaged or overloaded use of the machine. c. User disassemble and maintenance the extruder without the manufacturer's permission. d. Users modify or install the attachment without the manufacturer's permission. e. User does not operate as specified in the instructions. f.
- Page 8 General Troubles and Eliminations Ⅶ. The fault The possibility caused reasons Solved ways performance The motor of hot air gun was stop. Check the rotor, stator and switch of hot air gun, replace them if broken. No hot air wind Hot air gun heating element was Replace the heating element.