Inserting The Batteries Into The Remote; To Pair Remote With The Tv; Standby Button; Turning On/Off The Tv - Nokia Smart TV 2400A Manual

4.1. Inserting the batteries into the remote

Lift the cover gently. Insert two 1.5V - size AAA batteries. Make sure the (+) and (-) signs match (observe correct
polarity). Do not mix old and new batteries. Replace only with same or equivalent type. Place the cover back on.
1 2
1
2

4.2. To pair remote with the TV

When TV is turned on for the first time, a search for accessories will be performed after the initial setup starts.
You will need to pair your remote control with your TV at this point.
Press and hold the Source button on the remote until the LED on the remote starts to blink, then release the
Source button. That means the remote is in pairing mode.
Now you will wait for the TV to find your remote. Select the name of your remote and press OK when it appears
on the TV screen.
When the paring process is successful, the LED on the remote will go off. If the pairing process fails the remote
will enter sleep mode after 30 seconds.
In order to pair your remote later on, you can go to Settings menu, highlight Remotes & Accessories option and
press OK to start a search for accessories.

4.3. Standby button

Press and hold the Standby button on the remote control. Power off dialogue will appear on the screen.
Highlight OK and press the OK button. The TV will switch into standby mode. Press briefly and release to switch
the TV into quick standby mode or to switch on the TV when in quick standby or standby mode.

5. Turning on/off the TV

(Turning On/Off method may vary depending to model.)
13