Nokia Smart TV 2400A Manual page 15

After unpacking, allow the TV set to reach the ambient room temperature before you connect the set to the
mains.
Connect the supplied adaptor to a system that supplies 100-240 V AC, 50/60 Hz. The TV will switch on
automatically.
In order to supply the power via the cigarette lighter socket of your vehicle, plug one end of the cigarette
lighter adaptor cable (car plug - can be purchased separately if not supplied with the TV) into the vehicle socket
and plug the other end of the adaptor cable into the DC 12 V terminal on the back side of the TV.
Be sure to ground the connection properly
Connect the ground terminal of the AC adaptor with the ground terminal provided at the power outlet
using the enclosed power cord. If the provided plug does not fit your outlet, consult an electrician for
replacement of the obsolete outlet. Surely connect the ground wire.
To switch on the TV from standby
If the TV is in standby mode the standby LED lights up. To switch on the TV from standby mode either:
• Press the Standby button on the remote control.
• Press the centre of the control switch on the TV in.
The TV will then switch on.
To switch the TV into standby
The TV cannot be switched into standby mode via control switch. Press and hold the Standby button on the
remote control. Power off dialogue will appear on the screen. Highlight OK and press the OK button. The TV
will switch into standby mode.
To switch off the TV
To power down the TV completely, unplug the power adaptor from the mains socket.
Quick standby mode
In order to switch the TV into quick standby mode either;
• Press the Standby button on the remote. Press again to go back to operating mode.
• Press the centre of the control switch on the TV in and hold it down for a few seconds.
• Press again to go back to operating mode.
5.3.2. Connected with low voltage adapter
Switching on the TV using car plug
1. In order to supply the power via the cigarette lighter socket of your vehicle, plug one end of the cigarette
lighter adaptor cable (car plug - can be purchased separately if not supplied with the TV) into the vehicle
socket and plug the other end of the adaptor cable into the DC 12 V terminal on the backside of the TV.
Then the standby LED will light up.
2. Press the Standby button on the remote control or press the centre (optional) of the control switch on the
TV in. The TV will then switch on.
3. Adjust the antenna position for better reception or reinstall TV channels if necessary.
Switching off the TV
1. The TV cannot be switched into standby mode via the control switch. Press and hold the Standby button
on the remote control. Power off dialogue will appear on the screen. Highlight OK and press the OK
button. TV will switch into standby mode.
2. Unplug cable connectors and power plugs.
ATTENTION: 12 V Input
V+ V+
V- V-
15