Table of Contents
Advertisement
NV-VP60GL / NV-VP60GC / NV-VP60GCS
8.7.
Optical Pickup Unit
1. Unscrew the screws.
2. Remove the spring holders and the springs.
3. Pull out the drive shaft and guide shaft.
All manuals and user guides at all-guides.com
8.7.1.
The optical pickup can be damaged by static electricity
from your body. Be sure to take static electricity
countermeasures when working around the optical pickup.
(Refer to the related page in this Manual about the
countermeasures.)
1. Do not touch laser diode, actuator and their peripheries.
2. Do not use tester to check laser diode. (Laser diode can be
damaged easily.)
3. The use of soldering iron with anti-static feature is
recommended when providing short-circuit to laser diode or
when removing it.
4. Solder the land on flexible cable of optical pickup unit.
Caution
28
Precautions in optical pickup
replacement
· When using the soldering iron without anti-static
feature, short-circuit the flexible cable terminal with a
clip before short-circuiting the land.
· After intended repair is finished, remove the solder
for short-circuit of laser diode in a correct way by
following the procedures described in this Manual.
Advertisement
Table of Contents
