Table of Contents
Advertisement
NV-VP60GL / NV-VP60GC / NV-VP60GCS
6.5.
SERVICE CAUTION-2
6.5.1.
CAUTION FOR AUTO TUNING
PROCEDURE
Auto Tuning will start by the following procedure.
1. Connect the DIN-RF Cable.
2. Connect the AC Mains Lead.
3. Turn on the VCR.
Auto Tuning will start.
Auto Tuning search for TV stations from VHS minimum
to UHF maximum and memorizes every tuned program
position. Other program positions are skipped.
Auto Tuning takes five or more minutes to complete
its search.
Do not touch the VCR during Auto Tuning.
Auto Tuning will stop halfway, if the VCR is operated
or the aerial lead and/or the mains lead are
disconnected.
In case the VCR stopped during Auto Tuning, the VCR
has to be reset and restarted. See the following item 2.
NOTE:
1. If the VCR is turned on with the antenna not connected,
all channels are skipped. Therefore, firmly connect the
antenna and then turn the VCR off and on again to
execute Auto tuning.
2. When Auto Tuning is canceled halfway, Auto Tuning
is not execute even if the VCR is turned off and then
turned on again,
In this case, Auto Tuning has to be restarted by the
following procedures.
a. Press EJECT and remove the Videocassette.
b. Keep UP and DOWN on the VCR pressed
simultaneously for 3 seconds or more during the
VCR on.
The channel displayed on the VCR display
disappears for moment then changes to 1.
c. Disconnect the AC mains lead and the reconnect
it.
d. Turn on the unit. Auto Tuning commences.
3. If you turn the VCR off during Auto Tuning, Auto Tuning
will stop halfway.
The VCR should be reset and restarted by the item 2 in
order to execute Auto Tuning.
4. If the VCR starts playback during Auto Tuning, Auto
Tuning will stop halfway.
The VCR should be reset and restarted by the item 2 in
order to execute Auto Tuning.
5. To cancel Auto Tuning Mid-operation, press POWER
During Auto Tuning (The VCR is turned off).
6. When the VCR is moved to the other area or country,
TV broadcasts should be stored again.
All manuals and user guides at all-guides.com
6.5.2.
When the cassette tape could not be uninstalled from an
electrical malfunction, There are 2 ways to remove a cassette
tape.
1. Removal by compulsory unloading.
2. Removal by manual operation by rotating the Loading
Motor with the batteries.
14
REMOVAL OF CASSETTE TAPE
a. Press FF and EJECT button simultaneously for more
than 3 seconds and set the Service Mode to 7.
b. Press STOP button in order to unload the mechanism.
(Pay attention to tape slack)
Service Mode Indication:
7 06:00 (STOP) → 7 0L:00 (EJECT)
a. Disconnect the AC plug, and remove the Top Panel and
the Front Panel by referring to the Disassembly
Procedures.
b. Connect five batteries (1.5V spec.) to the Loading Motor
in series for supplying 7.5V to rotate the Loading Motor
as shown in Fig. S1.
Fig. S1
Advertisement
Table of Contents
