Table of Contents
Advertisement
www.vax.co.uk
A
Fig.6/11
Grasp brushbar firmly and fit it into position by first
sliding end opposite the belt into the rectangular slot (A)
on side of cleaner. Pull other side of brushbar (B) into
place (Fig.6/12).
A
Fig.6/12
Belt may fit loosely when properly installed. Reposition
flat belt and bottom plate as described previously.
TurboTool Brush Bar Replacement
When brushbar brushes are worn, the brushbar should be
replaced.
Remove tool from hose and turn it so bottom faces up.
Press the latches on both sides of tool and remove
bottom plate (A) (Fig.6/13).
Fig.6/13
Unscrew the two Phillips screws and remove belt guard
(Fig.6/14).
14
maintenance
All manuals and user guides at all-guides.com
B
A
Fig.6/14
Remove brushbar including end plates (A) and discard.
Inspect belt to ensure that it is in good condition. If belt
is cracked, gouged or broken, replace it (see following
section).
Insert brushbar through belt and position belt over gear
teeth (B) on brushbar (Fig.6/15).
A
Fig.6/15
With curved ends down, slide end plates (A) of brushbar
into slots (B) on tool (Fig.6/16).
A
Fig.6/16
Replace belt guard (A) making sure not to pinch brush
bristles in guard. Turn brushbar, to make sure it rotates
freely (Fig.6/17).
B
B
Advertisement
Table of Contents
