Haier HAIH8IFMCE User Manual page 65

• set the value of the timer to " " , via
Note: the function remains active if no other key is pressed in
the meantime.
Activation of filter saturation indicators
These indicators are normally deactivated
(for both the grease filter and the activated carbon filter)
To activate them, proceed as follows:
- switch on the extractor hob by means of
- with the suction motor and the cooking zones turned off,
push and hold down the Selection area (7):
the LED " " (17) turns on at low brightness
the display (14) of the extractor fan shows the letter "G" – to
proceed with the activation of the grease filter saturation
indicator –
Note : push the Selection zone (7) again to display (14) the
letter "F" and proceed the odour carbon filter Active
- push the Selection zone (6), the LED "
switches to high brigthness, then, after 10 seconds, it turns off
and indicates that the ACTIVATION was completed.
Deactivation of filter saturation indicators
repeat the operation described above for activation;
- the LED " " (17) switches to low brightness, then,
after 10 seconds, it turns off to indicate that DEACTIVATION
was completed.
Filter saturation indicator
The hood indicates when it is necessary to perform
maintenance on the filters:
Grease filter
the LED " "(17) turns on
the display (14) shows the symbol "G" (for 10 seconds from
switching on)
Activated carbon odour filter
the LED " "(17) flashes;
the display (14) shows the symbol "F" (for 10 seconds from
switching on)
Reset filter saturation
After having serviced the filters (both the grease and/or the
odour activated carbon filters) press and hold the Selection
Area (7):
The LED " " goes out and the indicator count is
restarted.
Note: Repeat the operation if both filters signals are displayed
simultaneously.
Automatic operation
The hood will turn on at the most suitable speed, adapting the
extraction capacity to the maximum cooking level used in the
cooking zone.
Once the hob is turned off, the hood adapts its aspiration
speed, gradually decreasing it, so as to eliminate residual
vapours and odours
To activate this function:
Briefly push the Selection zone (7), the LED "
up to show that the hood is working in this mode.
;
" (17)
64
" (18) lights