Vax oasis complete V-133 Instruction Manual page 15

V-133 OasisComp User Guide v5.qxd:V-133 Oasis User Guide
the trigger (equals one wet stroke) (Fig 5/18).
Fig.5/18
Lift tool, and position it against riser.
Pull tool slowly over carpet without pressing trigger (dry
stroke) (Fig 5/19).
Fig.5/19
It is best to alternate wet and dry strokes as described
above. end with more dry strokes to aid in faster
drying of carpet.
Overlap strokes by 1/2 inch to help prevent streaking.
To avoid saturating carpet, do not use more than 4 wet
strokes over any one area. Always end with dry
strokes.
If additional cleaning is necessary, wait until the carpet is
completely dry before using the tool again.
Empty recovery tank when the motor sound becomes
higher pitched and there is a loss in suction (see
"Automatic shut-off", page 7).
When finished cleaning, follow "After cleaning"
instructions on pages 10 and 11 and "After using tool"
instructions on page 14.
Cleaning upholstery
Read "Before you begin cleaning" Instructions on
page 10.
Be sure to check the cleaning code on your upholstery or
refer to manufacturers cleaning instructions.
All manuals and user guides at all-guides.com
8/9/08
Place handle in upright position.
Ensure brushes are set to the OFF position.
Fill clean solution tank with Vax Carpet/Upholstery
Detergent according to instructions on pages 7 and 8.
Attach tool to end of hose.
Do not point tools toward people or pets.
Dry hands and plug carpet cleaner into a suitable power
outlet (Fig 5/20)
Fig.5/20
Turn carpet cleaner on. If necessary, refer to "Before using
tool" section to remove air from system.
Gently press the tool onto the fabric. Press the trigger and
slowly pull the nozzle over the fabric.
Overlap strokes by 1/2 inch to help prevent streaking.
Make additional strokes without pressing the trigger to
remove more moisture.
To clean in corners or creases, lift the tool one-half inch
from the fabric and press the solution trigger.
Vacuum up the solution with the tool without pressing the
trigger.).
For heavily soiled areas, it may be necessary to repeat the
cleaning process. Make crisscrossing strokes to the original
pattern; overlap each pass (Fig 5/21).
Fig.5/21
NOTE: Make no more than 2 passes with the solution over
any one area to prevent over-wetting and damage to
fabric.
14:44 Page 15
Vax Careline 0870 606 1248
15
cleaning